Palisade Fencing Heights and Security Levels

Height plays a crucial role in assessing the suitability of palisade fencing for a particular application. Below, the typical height categories for palisade fencing are correlated with the primary site types and functions.

1.2 m: Low-Risk Boundary Marking

The main purpose of 1.2m high palisade fencing is to act as a boundary marker. This type of fencing would typically be used for low-risk sites such as residential sites with low volumes of traffic, or within gardens.

If you are looking for Palisade Fencing, see https://directfencingandcontracting.com/services/security-fencing/palisade-fencing.

1.8 m: Standard Commercial Security

For commercial yards, car parks and light industrial sites a height of 1.8m is most commonly specified, with pointed or triple-pointed pales to provide a deterrent.

2.4 m and Above: High-Security Sites

For higher risk sites like utilities, warehouses and high-value compounds it is common to install palisade fencing at a height of 2.4m or greater, possibly incorporating a raked topping or anti-climb profile to help prevent scaling. Examples of such a contract can be viewed at Direct Fencing and Contracting.

Check Planning Rules First

Before ordering your Palisade fencing make sure to check the Permitted Development limits for your site, especially for fences near to highways and within Conservation Areas where there may be restrictions on height within Planning.

Account for Sloping Ground

Ground that is not level will require panels to reduce in height down sections, creating potential interlaces at the bottom of each section that will detract from the overall height of security that your fence provides.

Remember, pick a height to match the risk to your site, then you will have the best balance of security and cost and compliance.